"FlexReg" Model PLR5-DR2 Features

- Failsafe Switch Design assures continued operation even if switch contacts fail.
- Less than 30 micro amps current drawper regulator board when switched off. Batteries can be left connected for months without significant drain when the unit is switched off.
- 5A current capacity per regulator board yields 10A maximum total current rating.*
- 3 pin up/down adjustment port provides 32 programmable output voltages on each regulator board.
- High reliability Surface Mount components reduce weight and size.
- Ideal for redundant power applications.
- Low dropout voltage design.
- For 2 cell LiPo / LiIon or 5 cell NiMh / NiCad applications.
- Programmable voltage ranges from 5.75V to 6.65V (factory adjusted to 6.2V). **
- Dual regulator configuration supports dual battery configurations for either concurrent or failover redundancy.
- Integrated Switch and Battery voltage monitoring/charge port / DSC connection, plus charging port for 2nd battery.
- Customized output voltage ranges and adjustment increments available by special order at no additional charge.

*Normal flight operation with up to 6 high torque digital servos per regulator will not require additional heat sink when operational guidelines are followed.

** Available "E-Z Set" programming box with integrated digital voltmeter is recommended for best adjustment results.

Download the PLR5-DR2 Quick Start Manual

Download the PLR5 User Manual
Download the PLR5 Data Sheet                                                                          Contact Tech-Aero Support

Download Tech-Tip #0601 – Redundant Power Configurations